I could not get some (many in fact) keycodes working in the meson-ir config. They are: KEY_PROG1 … KEY_PROG2, …, KEY_F13 … KEY_F24, KEY_SETUP, KEY_O etc
My system is CoreELEC-Amlogic-ng.arm-19.2-Matrix_rc2-Generic
ir-keytable reads them, the codes are seen with ir-keytable -v and also ir-keytable -t shows them properly when pressed but it’s all
First, I tried to simply configure the remote button as the hardware button ‘O’ (Player process info) and wrote 0x57 = “KEY_O” but it’s no use, player doesn’t react at it. Then I tried to set it to KEY_PROG1 and redefine in Keymap Editor - no luck, the same. The Keymap Editor pretends to catch the button (“press the button in 5 sec” dismisses) but doesn’t redefine the rule as though the code were empty
The Keymap Editor sees the button when I define it, for examole, as KEY_GREEN in MYREMOTE.toml but this definition has side effects, that’s why I’d prefer to use KEY_PROG1 etc. So it seems like that only some of the keycodes can be used in the toml. So the questions are:
- Where can I get the full list of the codes available to use in the meson-ir remote config?
- Why KEY_O and the other KEY_* don’t work? More exact, they work in ir-keytable but no further