#*********************************************************************************************************
#this file is configuration for each factory remote device
# 	work_mode	  0 :software mode  1 :hardware mode 
#	repeat_enable	  0 :disable repeat 1 :enable repeat	
#
#	factory_code      each device has it's unique factory code. 
#			  pattern:custom_code(16bit)+index_code(16bit)
#			  examble: 0xff000001 = 0xff00(custom cod)  0001 (index)
#
#	release_delay	  unit:ms.release will report from kernel to user layer after this period of time
#			  from press or repeat triggered. 
#
#	debug_enable      0 :debug disable  1 :debug disable
#
# SW MODE:
#	bit_count	  how many bits in each frame	  
#	tw_leader_act	  time window for leader active 
#	tw_bit0		  time window for bit0 time.
#	tw_bit1		  time window for bit1 time
#	tw_repeat_leader  time window for repeat leader
# REG
#	reg_base_gen	  set value for PREG_IR_DEC_BASE_GEN	
#	reg_control	  set value for PREG_IR_DEC_CONTROL
#	reg_leader_act	  set value for PREG_IR_DEC_LEADER_ACTIVE
#	reg_leader_idle	  set value for PREG_IR_DEC_LEADER_IDLE
#	reg_repeat_leader set value for PREG_IR_DEC_REPEAT_IDLE
#	reg_bit0_time	  set value for PREG_IR_DEC_BIT0_TIME
#************************************************************************************************************* 
#amlogic NEC remote
factory_code	= 0xff000000
work_mode  		= 0
repeat_enable = 1
repeat_delay = 120
repeat_peroid = 33
release_delay	=	121
debug_enable 	= 1

key_begin
#		KEY	Code Key_Action			Kodi_Action
		0x59 116 #KEY_POWER			power			ON/OFF
key_end