#amlogic T95Z PLUS - example 1 

# Copy the Krypton remote.conf to the COREELEC partition of your SD card / USB flash drive or to /storage/.config/remote.conf and reboot.
# Your device will reboot again whilst changes are made to your device, to revert back to meson-ir just simply remove the file and reboot again.


factory_code    = 0xfe010001
work_mode       = 0
repeat_enable   = 1
repeat_delay    = 130
repeat_peroid   = 120
release_delay   = 20
debug_enable    = 1
left_key_scancode  = 0x51
#right_key_scancode = 0x01
#up_key_scancode    = 0x45
#down_key_scancode  = 0x55
#ok_key_scancode    = 0x41
# '#' means a comment(after # the reset of the line is ignored), I've tried to split it up, names/keys
# as you go down the remote and should make it easier to customise how you like
# * change this value for your desired function, a couple are given in comments



# fn_key_scancode       = 0x52 #MOUSE
left_key_scancode     = 0x50 #LEFT
right_key_scancode    = 0x27 #RIGHT
up_key_scancode       = 0x16 #UP
down_key_scancode     = 0x1a #DOWN
ok_key_scancode       = 0x13 #OK
mouse_begin
        0 0x25 #LEFT
        1 0x27 #RIGHT
        2 0x26 #UP
        3 0x28 #DOWN
mouse_end
key_begin
   0x40 116 #Power
   0x0f 164 #PLAYPAUSE (MUTE)
#    0x09 398 #RED
#    0x11 399 #GREEN
#    0x54 400 #YELLOW
#    0x4f 401 #BLUE
#    0x56 104 #PAGEUP (VOL-)

#    0x4e 109 #PAGEDOWN (VOL+)
    0x51 105 #LEFT
    0x50 106 #RIGHT
    0x16 103 #UP
    0x1A 108 #DOWN
    0x13 165  #ENTER (OK)
    0x4b 163 #previous song
    0x4f 208 #next song
    0x11 172 #HOME
    0x19 1   #ESC (BACK)
#    0x05 46  #C (CONTEXTMENU)
##   0x52 nn  #MOUSE (dont use this line, key is mapped in fn_key_scancode)
    
     0x01 11  #No.0
     0x4e 2   #No.1
    0x0d 3   #No.2
    0x0c 4   #No.3
    0x4a 5   #No.4
    0x09 6   #No.5
    0x08 7   #No.6
    0x46 8   #No.7
    0x05 9   #No.8
    0x04 10  #No.9
    0x42 14  #BACKSPACE
    0x00 23  #INFO
   0xf3 113 #MUTE
   0x10 114 #VOLUMEDOWN
   0x18 115 #VOLUMEUP
   0x41 364 #FAVORITES
   0x11 102 #HOME
   0x19 158 #BACK
   0x43 139 #CONFIG
key_end
repeat_key_begin
    0x4b 168 #REWIND
    0x4f 208 #FASTFORWARD
repeat_key_end