Updated two of my S912 boxes with no issue, but my MCE USB Receiver isnt working now.
Tried using the other LE Module Drivers, but still not working.
ir-keytable shows:
LOUNGE-ER:~ # ir-keytable
Found /sys/class/rc/rc0/ (/dev/input/event2) with:
Name: meson-ir
Driver: meson-ir, table: rc-empty
lirc device: /dev/lirc0
Supported protocols: lirc rc-5 rc-5-sz jvc sony nec sanyo mce_kbd rc-6 sharp xmp imon
Enabled protocols: lirc
bus: 25, vendor/product: 0000:0000, version: 0x0000
Repeat delay = 500 ms, repeat period = 125 ms
Whereas downgrading to 9.0.2 it shows:
LOUNGE-ER:~ # ir-keytable
Found /sys/class/rc/rc0/ (/dev/input/event2) with:
Name: meson-ir
Driver: meson-ir, table: rc-empty
lirc device: /dev/lirc0
Supported protocols: lirc rc-5 rc-5-sz jvc sony nec sanyo mce_kbd rc-6 sharp xmp imon
Enabled protocols: lirc
bus: 25, vendor/product: 0000:0000, version: 0x0000
Repeat delay = 500 ms, repeat period = 125 ms
Found /sys/class/rc/rc1/ (/dev/input/event3) with:
Name: Media Center Ed. eHome Infrared Remote Transceiver (147a:e03e)
Driver: mceusb, table: rc-rc6-mce
lirc device: /dev/lirc1
Supported protocols: lirc rc-5 rc-5-sz jvc sony nec sanyo mce_kbd rc-6 sharp xmp imon
Enabled protocols: lirc rc-6
bus: 3, vendor/product: 147a:e03e, version: 0x1001
Repeat delay = 500 ms, repeat period = 125 ms
I was actually using this build previously by @boot2k3 which had the fix for deinterlacing : Need testers for S912/S905W green/red lines issue
The files been removed in the post so I cannot downgrade back to this version as I deleted it afterwards.
Any suggestions?