Allo DigiOne support - Odroid C2

Single Board Computers Odroid C2
1

Hi,
I am planning to replace my RPi3 player with a Odroid C2 boardf (eMMC 128G). My current player is based on RPi 3B - with LibreElec 8.2.5 + DigiOne audio out. I am writing to ask if the DigiOne board is supported on C2 by CoreELEC.

Thank you,

AlleyCat

2

No, this board was designed for the RPi, the 40pin connector on the C2 has a different layout.

3

Hi Adam,
Thanks for the fast reply. What about custom wiring of the I2S pins? If you look at the DigiOne board pinout you will see the list of signals that could perhaps be mapped to the C2 pinout.

image
image776×1088 107 KB

Regards,
AlleyCat

4

You can’t map them as such in software unfortunately.