Thanks Kostaman. Sorry for late reply but not been available for a coujple of weeks. I did take a look at the config.ini file and it has a single line WOL=0 So it is already disable it appears. Still have this annoying problem losing CEC and ARC between the TV and Onkyo AVR requiring a reboot of the TX9 Pro box running 9.2.3 which then clears thsio problem which comes back sometime later for no apparent reason I can put my finger on. And happens again even though I leave the TX9 box running all the time when not being used.
Some more test I have carried our shows that if I power down the box but leave it connected to the power then I lose CEC/ARC TV to AVR, so this thus appears not to be a CoreELEC problem but something in the box hardware that is interfering with the Onkyo CEC/ARC funcfion. BUT if I disconnect the power enitrely from the TX9 or unplug the HDMI lead to the Onkyo then the CEC/ARC comes back fine between TV and AVR ?? So does that help in giving a clue as to solving this problem that others here, plus my friend with a GT King box, also have too ??
Thanks in advance for any response to this problem or any others with any relevent input
You only can modify config.ini. the max_freq_a55 is for the SM1 SoC added.
You can set max_freq_a55=xxxx (SM1) in config.ini and it will be handled correct by boot.ini.
Internal max_freq_a55 is same as max_freq_a53 so you also can use max_freq_a53=xxxx (G12*)
So do I need to add the line cec_func_config=‘00’ to my config.ini file to disable all CEC functions or is it already by default set to all off = ‘00’ ??
Also remember that I have a Tanix TX9 Pro box, not an Odroid so assume this all still applies to my box. Also just awaiting deliver of an X96 Max + S905X3 4/64GB box which is ridiculously cheap for such a high spec box
As the Tanix TX9 Pro is a S912 SoC I am not sure if it can be disabled completely. At least not in suspend mode as CE does not have control over the bootloader bl301 blob. All other devices using Amlogic-ng image including bl301 injected and/or Odroid N2/C4 also support disable of CEC for Wakeup and can be set in Kodi CoreELEC Settings.
so set in config.ini (if not available in CE settings):
should disable it, yes
Different libCEC versions can be chosen by open a SSH connection and type:
remove any libcec config (default 4.0.4 will be used):
rm -rf /storage/.config/libcec-4.*.conf
When CEC is working after booting into CE and CEC is stopping working later it’s more related to libCEC then the CEC driver itself.
It doesn’t work… With the CEC adapter showing as disabled, coupled with the setting in config.ini set to ‘0’, all the sliders in the CEC settings set to off, my box is still turning on when the TV is turned on.
Also, the sliders should not make a difference if the CEC is set to disabled.
Someone mentioned that this should be turned off in the dtb.img if all these settings have no effect… If I download an upgrade image for my box, how would I go about doing this?