CoreELEC Settings Hardware Section

General Guides & How-tos
9

Additional CoreELEC 19 options

Device Tree

The settings only apply if the underlying hardware does support it!
device_tree
System LED

  • Choose preferred mode for the system LED

Red LED

  • Choose preferred mode for the red LED

SPI Interface

  • Enable/disable SPI interface on the GPIO pin header

IR Protocol Type

  • Default IR protocol used for meson_ir

eMMC Speed Mode DANGEROUS

  • Choose eMMC speed. Please change this setting only when booting from external boot media like uSD or USB. Then check with dmesg if eMMC is working properly before apply the setting when booting from internal eMMC! Otherwise you can stop prevent the device from booting!
    In such case boot from external boot media, mount the internal memory and remove the file /CE_FLASH/dtb.xml and replace your /CE_FLASH/dtb.img by the used default one.

DVB GPIO support

  • Enable/disable DVB GPIO support on the GPIO pin header

WiFi SoC SDIO Speed

  • Low/normal WiFi SoC SDIO speed. This is only needed for some devices with a bad WiFi SoC.