H96 Pro+ S912 Standby mode


#148

Here is the log: screenlog.0 (134.7 KB)

  1. Starts Coreelec with freshly plugged in power supply. (Blue light turns on)
  2. Coreelec shuts down
  3. Press the power button once: short blue light
  4. Press the power button a second time (Blue light turns on): Android starts (Log ends at half of the boot process)

Nothing is connected via USB.
Strangely the box starts when UART adapter is reading, Android and not Coreelec?! I mean, I hadn’t had that before.

** Bad device mmc 0 **
(Re)start USB…
USB0: USB3.0 XHCI init start
Register 3000140 NbrPorts 3
Starting the controller
USB XHCI 1.00
scanning bus 0 for devices… 1 USB Device(s) found
scanning usb for storage devices… 0 Storage Device(s) found
** Bad device usb 0 **

Does that mean something?


#149

With 600Mhz it takes quite a long time to change paths (external hard disk) in the file manager. In other words it always hangs up for a few seconds (annoys quite a bit). I can’t say to 100% whether it’s because of it. I haven’t noticed any other artefacts yet.
I have completely rebuilt Coreelec to avoid any related problems.

Edit: Strangely enough, the problem just disappeared?!


#150

:wink:

I have seen this stucking of the system also with a class 4 SD card. With a class 10 SD card the problem was gone.


#151

I didn’t notice it was a slow class 4. I have now replaced it with a class 10 and everything runs smoothly, thanks!