Hi, I tried some new things and have some updates, but also some questions.
I followed the guide How to configure IR wakeup code and it worked, but not fully how I want. I maped my Odroid as Windows Media Center on my Harmony, and it has 3 IR codes registrered : Power on, power off and power toggle. When following the guide and executing ir-keytable -u, only the Power toggle code was detected. I succeeded to edit the config.ini and now the Power toggle can turn my Odroid on. But I would prefer to have seperate buttons to turn on and off my Odroid. But the Power on IR code wasn’t detected, I don’t know why. Could someone help me to find why Power toggle was detected but not Power on ?
I also found why IR receiving by the Odroid was so much worse than all the others devices I have. It was because the Odroid box was on (I have the default Odroid box selled in the CoreElec pack). With the plastic cover removed, it works much better. It’s because the IR receiver of the N2+ is completely covered up when the cover is on. But that’s strange, I though the cover was transparent enough for the IR signals to go through. Apparently I was wrong. I can still poke a hole through it for the IR receiver to work, but it’s a bit unconventionnal. Does someone have a solution for this ?
As you can see, the cover completely covers the IR receiver.
Finally, I have a last question but it doesn’t concern CoreElec or Odroid. It concerns logitech Harmony and my projector. My BenQ W1090 have to be muted at all time, because if not it outputs the HDMI sound. But I have an AV Receiver so I don’t need it. The problem is that my projector doesn’t remember the muted status when restarting. So I have to press mute on time after each launch. But I don’t know where I have to set this up in MyHarmony. I have 2 possibilities:
I can set this “muted” status in the “devices” area, in the “power” settings:
Or I can set it up in the “activities” area, and tell before all my activites to send the mute command to my projector before everything
Where should I set it ? I want the mute command to be sent when launching on activity, and also when launching only the projector outside of any activity. I would have a question : In an activity (2nd image), does the “Power On” at the projector line means it’s only sending the “power on” command, or does it means it’s executing the full “Power on” sequence previously set up in the device settings ? Does it take into account what has been set up to power the device on in the device settings or does it ignore it and just send the “power on” IR code ?
(sorry if that is unclear, english is not my mother language. I also know it’s not really the place to ask my last question but it’s not a very important question, but maybe someone here knows myHarmony enough to have an answer)
Thanks in advance for any answer, and have a great day and a great 2021