I have a MeCool M8S Pro+ (S905X) which has Coreelec (9.2.7, not ng) running without problems on microsd card. Recently I have tried getting the device running on Coreelec 19.1-Matrix_rc2. Coreelec loads correctly with my chosen dtb and the HDMI-CEC even works. But I have a problem getting the OEM…

Kodi stopped? no log, no support [image] How to configure IR remote control Guides & How-tos IR remote controls can be configured in 1 of 2 ways in CoreELEC, both are detailed in this guide below. meson-ir meson-ir allows you to use almost any IR remote controller to co…

Apologies. I have attached a start up log (the remote and cfg files have been deleted). It shows the start up and also Kodi stopping, shortly followed by me running the ir-keytable -p… command kodi.log (91.8 KB) Is there any other logs, other than this which I can extract. I have turned on debu…

when you need to stop kodi how helpful is kodi.log? dmesg | paste after yo tried to run ir-keytable

OK. I first attach my SSH commands and response [IRTable_Output_1] As you can see, after stopping Kodi and eventlircd, I tried running the ir-keytable command twice. After running each ir-keytable command, I pointed my remote at the device and pressed a couple of buttons. The I ran CTRL-C to abo…

try ir-keytable -u ir-keytable -u -v If there is still no output on console the IR transmitter/receiver is broken.

Here are the results after stopping kodi and eventlircd After command ir-keytable -u, console shows: /sys/class/rc/rc0//protocols: Invalid argument Waiting for IRMP decode event. Please, press CTRL-C to abort. After command ir-keytables -u -v, console shows: Found device /sys/class/rc/rc1/ Fou…

you have something strange on your device. Make a complete clean install with Matrix and try just after first boot again. All receivers are disabled, only RC5 is enabled. So when your remote is not RC5 it will not decode anything.

This is a clean install. I had to setup using a mouse because the remote was not working. Maybe I will repeat the clean install and not connect the usb tuner before trying to set up the remote. I will also try it before setting the device up for regions etc

Happy to report that a clean re-install of the image successfully eliminated the issue. I have even stuck the USB tuner back on and device still booted into Coreelec. Now for the next step of getting device drivers for DTB tuner - that is for another day One thing I did notice for my device. Whi…

[image] sirzur: While the explanation for “How to configure IR remote control” stated that I had to add a toml extension for scan code file for Coreelec 19, I kept getting an error, until I just removed the toml extension and edited the cfg file accordingly Can you explain more in detail what…

CoreELEC Forums

No response to ir-keytable

Help & Support Remote Controllers

Portisch 21 April 2021 09:33 2

Kodi stopped?

no log, no support

About | FAQ | Terms of Service | Privacy Policy | Legal Notice