Amlogic-no Discussion

Development Development & Testing
1301

Installation of 20250107.img on eMMC does also not work with this dtb.img

UART log Install with new dtb.img

1302

Maybe rev.a do require more stuff to be changed, tomorrow.

1303

Thnx, no rush.

1304

Please try this with Odroid N2 rev.a:
g12b_s922x_odroid_n2.dtb (58.9 KB)

1305

Does not work, rebooted 3 times before I stopped UART the log.

1306

@Tim_Taylor @Sholander please test this dtb for rev.a:
g12b_s922x_odroid_n2_rev_a.dtb (74.5 KB)

1307

Bingo :heart_eyes: This version works; installed nightly, did initial setup, reboot, cold boot, all works without any glitch. Did not test further, but expect it’ll work the same as for others.
Installation UART log

1308

Thanks @Portisch but HDR 10+ does not work yet.

1309

In today’s nightly I get HDR10+. X96X10 device

1310

Done, installation works using Your dtb + CoreELEC-Amlogic-no.aarch64-22.0-Piers_nightly_20250108-Odroid_N2 on SD card and USB stick
N2: rev a
Petitboot: spiboot-20220317

1311

I found one of my first N2’s (rev a) and tested latest nightly (08-01).
First boot with included dtb fails. Replaced dtb with the one you provide here (
g12b_s922x_odroid_n2_rev_a.dtb), that one boots and reboots without issues! (I only use eMMC, nothing else)

1312

The rev a dtb works for me too on a 2GB N2. I couldn’t contribute as this went on as I don’t have UART so It’s a big thank you to those who have and to @Portisch.

1313

I will prepare some test dtbs for rev.a tomorrow to really identify the cause.

1314

Can confirm HDR10+ working fine for me. Thanks.

1315

So here some N2 rev.a DTBs to test please:
g12b_s922x_odroid_n2_rev_a_v1.dtb (74.8 KB)
g12b_s922x_odroid_n2_rev_a_v2.dtb (74.8 KB)
g12b_s922x_odroid_n2_rev_a_v3.dtb (74.8 KB)

Additional:
g12b_s922x_odroid_n2_rev_a_v4.dtb (74.8 KB)

Please just report which one is working on N2 rev.a.
It’s only rev.a in the DTB but it should also boot fine on rev.b, at least it is here.
So there is no harm when trying on rev.b N2.

1 Like
1316

My N2 is booting up with all three versions

1 Like
1317

Thx, I added a v4 above. Please try this as well.

1318

Also works with version 4

1319

All 3 boot for me too but ai had a lock up quite soon with v1. Incidentally, I noticed I couldn’t get into CoreELEC configuration.

Off to test v4 now.

1320

V4 also boots and I can get into CoreELEC configuration.