Some devices that CoreELEC supports have a VFD similar to the TX3 Mini as shown below. [tx3] Many of these are supported in our builds thanks to @TheCoolest . To get these working is really easy. Goto Arthur’s VFD repository here . Download the configuration that matches your device and rename it…

Thanks for looking into this and sharing the vfd.conf. This box is named as X4Plus_S905W2 printed on the Silk board. I am out of station at present and not near to this box. I will test this conf and confirm you back once I have returned back.

For infornation. If it hasn’t been published yet. x96 m200 matches configuration x96-m300.vfd.conf Chip TM1628

@TheCoolest . My box is Amlogic S905X3 with 4/64 GB. It is currently running CoreELEC (official): 21.3-Omega (Amlogic-ng.arm) and Linux version: 4.9.269 (portisch@ubuntu). I am able to boot using sm1_s905x3_4g.dtb. All the hardware components are working including LAN, WiFi, Bluetooth, USB 2.0 and US…

The filename in the “configfiles” folder: vfd.conf Not hk1-box-vfd.conf and etc. Still no luck? Put the file…and box reboot. What is the correct name of the box?

Hi, Thanks for replying. Yes. I have downloaded and copied the vfd.conf to /storage/.configlocation as mentioned in the Post #1 on this thread. I have rebooted and tested. still no luck. The box is named as Prime, no other names I could find on this box. On the PCB board it is written as EB_X3PRO_S9…

[image] corereactor: chipset FD6551 maybe… [image] Magicsee N5 Hardware Disclaimer: This post is intended only for those, whose VFD isn’t working with the existing vdf.conf file and driver. @2small @akella130986 @ffimon @supermegazord After some diggin…

I have tried to configure the vfd as per the post you have shared. I am getting below given error message. amls905x3ndbx:\~/downloads/openvfd # systemctl stop openvfd amls905x3ndbx:\~/downloads/openvfd # sh stop_service.sh amls905x3ndbx:\~/downloads/openvfd # sh test_led.sh No command line options …

I would just try with the vfd.conf and skip the rest: “SSH to box and run the following commands”…

After correcting the unzipped files permission I am getting this message. amls905x3andbx:~/downloads/openvfd # sh ./test_led.sh No command line options were found, showing usage instructions. Usage: OpenVFDService [-t] [-dt TYPE] [-h] -t Run OpenVFDService in display test mode. …

I have already downloaded the magicsee-n5-vfd.conf (1.5 KB) and renamed that as vfd.conf. It is placed inside /storage/.config/ below given is the outcome of the file in the destination. I have rebooted the box after copying the vfd.conf. The vf display is still blank. nano /storage/.config/vfd.co…