CoreELEC 21.2-Omega Amlogic-ne Discussion

[evertonmdz]

Amlogic-no Discussion

I tried 20250320 and it also gave an error in the super partition. The only 100% functional version for me is 20241220 CE NE which was discontinued, the sleep mode works normally, unlike the NO. Which instead of returning from sleep mode, simply restarts the system. I am using this discontinued version, because Kodi 21 sometimes stutters when pausing. Or returning a scene. And with some types of subtitles too, which was resolved in CE 22 with these settings in advancedsettings. <gui> <algor…

Try this, if it’s the same problem as me I only had success like this. On the CE-22!

@bazzle

I have the same issue in NE. I tried many configurations of gui setting and resolutions but still gives issues. Picture flashes etc when opening or closing ui etc.
Was the same in NO but that was fixed a few updates ago.

This happens when the gui is in 4k, or when it is activated to double the frames, 25 to 50 frames or pull down 24 to 60 frames.

@bazzle

Sadly. No change . Small gui in top left corner.
Video flashes when gui opened. Tox3 905x4_4gb

Try this:

Amlogic-no Discussion

Ok, the “issue” is caused because of done video calibration with 4k GUI but with GUI scaling enabled. So “wrong” 1080p values are then stored in GUISettings.xml. Open SSH connection and run this: systemctl stop kodi; xmlstarlet ed -L -d "//settings/resolutions" /storage/.kodi/userdata/guisettings.xml; systemctl start kodi; Video calibration will be removed but Kodi show up normal. So adjust again the video calibration afterwards when need.